Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateFast, Reliable Garage Door Spring Repair Across Andover
If your garage door won’t lift, or it comes up a few feet and stops, there’s a good chance a spring has failed. We repair and replace garage door springs throughout Andover, and we know what the housing stock here does to them. Our technicians have up to 9 years of experience, and garage doors are all we do. Call (888) 315-6660 for a free estimate. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday.
Why Andover Homeowners Call Manchester Garage Door Repair Co for Garage Door Spring Repair
Andover is a small, rural town, and garage doors here don’t live the life they do in a dense suburb. Most of them hang on one- or two-car garages attached to single-family homes, many of those farmhouse-style or 1970s – 1990s builds. That means a lot of original equipment still in service, and a lot of springs that are simply past their cycle life.
When an Andover spring lets go, we’re the call because we specialize in exactly this. Spring repair is a named, standalone service for us, not something squeezed in between other trades. We work on whatever system is in your garage, from Amarr and Wayne Dalton doors to older Raynor hardware, and we diagnose the whole door rather than swapping one part and leaving the rest to fail.
We also hear the same frustration from Andover homeowners again and again: they call a company on the other side of the Hartford metro and wait days for a callback. We dispatch fast, and our local pros are vetted and licensed and insured as their state requires. The written estimate is agreed before any work starts, so there’s no invoice surprise on the other side of the job.
Styles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
Our Garage Door Spring Repair Services in Andover
Spring work is the most safety-critical repair on a garage door. Torsion springs and cables are under high tension, and a spring that’s been cut free without the shaft clamped can cause serious injury. We handle that part. We’d rather you call us than try it yourself.
Torsion Spring Replacement
Most modern Andover doors run on a torsion spring mounted above the door on a shaft. A typical torsion spring replacement in Andover runs $180 – $340 for one spring. Springs are usually replaced as a matched pair because if one has failed, its twin is on the same cycle count and isn’t far behind; a pair runs about twice that. We clamp the shaft, release tension, and balance the door before we trust the opener again.

Extension Spring Replacement
Older Andover garages often have extension springs running along the horizontal tracks, with safety cables threaded through them to contain a break. Extension spring replacement is priced in the same $180 – $340 range per spring. If your cables are missing or frayed, we replace them as part of the job, because an uncabled extension spring is a genuine hazard.

Broken Spring Repair
A snapped spring is obvious: the door won’t lift by hand, the opener runs but the door doesn’t move, or you hear a sharp bang from the garage. We diagnose which spring failed and why, then look at the surrounding hardware so a new spring isn’t fighting a bent track or a binding roller. Call (888) 315-6660 for fast help.

Spring Adjustment
Sometimes the spring hasn’t broken, it’s just lost tension and the door feels heavy or closes too fast. Spring adjustment is the least expensive path if the hardware is still sound. We test balance and travel, then reset the tension to match the door’s weight.
Safety Cable Installation
On any extension spring setup, safety cables are mandatory. If your older Andover door has bare extension springs with no cable through them, that’s a repair we’d make a priority. See our garage door spring repair team for the full range of spring work.
Trusted Brands We Service in Andover
Your door, your brand, our specialty. We work on equipment from Amarr, Wayne Dalton, Raynor, and a handful of other major manufacturers, which means we can service whatever is already on your garage instead of pushing a specific brand. On older Andover homes, that matters: a Raynor or Wayne Dalton door from the 1980s is still perfectly serviceable with the right spring and hardware. We don’t stock parts on a truck; we identify what’s needed, order it, and return to fit it correctly.
See the difference
Before
After
Before
After
Before
AfterCommon Garage Door Spring Repair Problems We See in Andover Homes
- Original springs on 1970s – 1990s doors snapping in a cold snap. Andover’s inland winters bring real freeze-thaw and ice storms, and a spring that has lost most of its cycles is most likely to fail on a fast cold night. When it goes, the door is suddenly too heavy for the opener.
- Grit tracked into the tracks from long gravel driveways. This is the Andover problem. Plowed subdivisions keep the grit off; dirt and gravel roads don’t. Sand and debris get carried into the rollers and tracks, the door binds, and the springs get pulled out of balance on one side.
- Warped or rotting wooden doors throwing off the balance. Humid summers and freeze-thaw cycles warp early one-piece and sectional wooden doors. A warped door loads the spring unevenly, and the hardware wears out faster than it should.
- Openers doing the spring’s work. On a door that’s hard to lift by hand, the opener strains to pull it up. That’s a spring problem masquerading as an opener problem.
How a typical spring job goes in Andover
On a 1970s-and-older one- or two-car garage, the homeowner notices the door getting hard to lift by hand and the opener struggling to raise it. The usual cause is an original or decades-old spring that has shed its spring cycles, or snapped, and the drums and cables are no longer working in balance. A qualified local pro clamps the torsion shaft, releases the tension, replaces both springs as a pair, fits safety cables on any extension spring setup, then checks door balance, track alignment, and the photo-eye sensors before the opener is trusted again.
Pricing for Garage Door Spring Repair in Andover, CT
A typical spring repair in Andover runs $180 – $340 for one spring, and about double for a matched pair. The written estimate sets the final price, and it’s free. What pushes a job toward the top of the range: a door that also needs track realignment or new rollers because of gravel-driveway grit, a rusted torsion shaft, or cables that are shot. If the surrounding hardware is sound, you’ll land near the bottom.
| Service | Typical estimated range |
|---|---|
| Spring Repair (per spring) | $180 – $340 |
| Cable Repair | $130 – $250 |
| Track Realignment | $120 – $240 |
| Roller Replacement | $110 – $220 |
| Opener Repair | $120 – $320 |
| New Door Installation | $700 – $2200 |
When a door is genuinely past its service life, retrofitting the spring and cables can be throwing money at a door that’s going to fail again. New door installation runs $700 – $2200. We’ll tell you which side of that line you’re on. Call (888) 315-6660 for a free estimate.
We Also Serve Cities Near Andover
Serving Andover and the towns around it, we cover garage door spring repair in Bolton, Manchester, Rockville, and Vernon. If you’re just over the town line, chances are good we’re already working nearby and can fit you in. One trade, done completely: repair, opener service, springs, and installation, all in one place.
Serving Andover, CT – Our Local Coverage Area
We serve Andover and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Garage Door Spring Repair in Andover
Repair it if the door panels and hardware are sound; retrofit if the whole door is failing. A 1980s torsion spring that’s still in service is well past its expected cycle life, so replacing it as a matched pair makes sense. But if the panels are warped or the door is a wooden one-piece that’s rotting, a new spring just burdens old hardware. We’ll give you a written price for both options so you can decide. Call (888) 315-6660 for a free estimate.
Very likely, yes. If the door is hard to lift by hand, the springs aren’t carrying their share of the weight and the opener is doing the work. That strains the opener motor and gears every time you open the door. Get the springs checked before the opener fails too. Call (888) 315-6660 for a free estimate.
Because dirt and gravel roads carry sand and grit onto the tires and shoes, and that gets tracked straight into the tracks and rollers. On a plowed suburban street it doesn’t happen the same way. It causes binding, uneven strain on the springs, and premature roller wear, which is why a spring repair here often needs a track realignment and new rollers alongside it. Call (888) 315-6660 for a free estimate.
Yes. Any extension spring setup should have a safety cable threaded through the spring so that if it breaks, the spring is contained rather than flying loose. If your older door has bare springs with no cable, that’s a safety issue worth fixing right away. Call (888) 315-6660 for a free estimate.
A standard spring replacement usually takes a couple of hours once the parts are on hand, and we can often get someone out the same day. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday. A call outside dispatch hours is booked into the next opening. Call (888) 315-6660. Estimates are free.
Ready to get your door working again? Call (888) 315-6660 for a free estimate. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday. Garage doors are all we do, which means they’re all we think about.
Written by the team at Manchester Garage Door Repair Co.